Sonic pad usb not detected reddit. My Ender 3V3SE connected to the same pad doesn’t suffer.
Sonic pad usb not detected reddit Might I ask why you're using a thumb drive to transfer files? Since then I am not able to get any USB connection - neither to the printer, nor does the light of the USB-stick indicate that it accesses it (it is constantly red/on). Due to the global supply issues with some electronic components the MCU chip was changed which may be why you are experiencing this issue. 6. A factory reset also didn't help. D) Move the Sonic Pad further from the printer. Any recommendations? Whenever I try to connect a usb with files to my sonic pad, it doesn’t work, I have tried so many things, it was working two days ago. always the . 145 Any help would be most appreciated! Creality Ender-3 Max Neo and Sonic Pad. Can someone please help? Update: It was fixed. A) a better quality USB cable, the one supplied wasn’t the best. 0. i’ve probably tried more stuff but don’t i have a sonic pad, but now I recalibrate the Z probe and after a restart the sonic pad cant connect my printer anymore. B) block the 5V rail on the USB either with tape or a USB PortaPow USB power blocker. I tried formatting it in both FAT 32 and NTFS but the sonic pad still doesn't recognize it. Is the stick formatted Fat32? I would try that first, making sure it’s not exfat or ntfs. I have just checked the manual for the Sonic Pad and it looks like page 9 section 2. Hello, the usb drive that came with the Sonic Pad got corrupted. Hopefully the link above should have all the info you need to In theory you should be able to pick the printer on the Sonic Pad to initiate the firmware install for the printer. -swapping usb cables with the f103 that was working-swapped the entire sprite extruder with the f103 one-removed all printers from sonic pad and tried re-doing the config with 1 printer alone. I follow the prompts on the Sonic Pad and I just keep getting the message "printer not ready", and I'm correctly connected to the printer, usb cable runs from Sonic Pad usb port 1 to the printer usb-c port. I can't seem to get past this point, and I have the most updated Sonic Pad firmware V1. For the USB stick it is the same problem on all ports - side and back. 7 on-wards should cover the process for updating/installing the firmware. I didn’t get key error 92, only key error 1. Here is a link to the manual if you need it Sonic Pad Downloads It appears that an update was applied automatically, because its no longer asking to update on launch, and now any USB drive I insert is not recognised and comes back to the computer as needing repair. 49. even a factory restore dont help. My Ender 3V3SE connected to the same pad doesn’t suffer. always the Hello, the usb drive that came with the Sonic Pad got corrupted. I try-out different usb port.